Estimate Exterior Paint for Walls and Gables

Work out siding and gable paint quantity from a simple rectangle plus optional triangular gables. The result is a planning estimate, and coverage should be set to the exterior product you buy.

Calculator

Enter the building’s plan length and width and the wall height to treat the four walls as 2 × (length + width) × height, the same rectangle formula as a room. Add triangular gables if you are painting them (each gable is ½ × width × height to the ridge). The default coverage of 250 sq ft per US gallon is the low end of the 250–300 sq ft range on the Sherwin-Williams Duration Exterior Acrylic data sheet — a thicker film, and often a rougher surface, than many interior wall paints. Raise or lower the rate to match your product and substrate.

Openings to subtract (optional)

Counts default to zero so nothing is subtracted until you add a door or window. The example sizes (a 3 ft × 6 ft 8 in door and a 3 ft × 4 ft window) are editable starting points, not required dimensions.

Formula and a worked example

Wall area = 2 × (length + width) × height

Each triangular gable = ½ × gable width × height to the ridge

Paintable area = wall area + gables − openings

US gallons = (paintable area × coats) ÷ coverage

Example: a 40 ft × 24 ft footprint, 9 ft walls, two gables that are 24 ft wide and 6 ft to the ridge, two coats, 250 sq ft/gal, and no openings entered. Walls = 2 × (40 + 24) × 9 = 1,152 sq ft. Gables = 2 × ½ × 24 × 6 = 144 sq ft. Total 1,296 sq ft. Two coats need 2,592 sq ft of coverage, or 2,592 ÷ 250 = 10.37 US gallons (about 39.2 litres), which rounds up to 11 gallons.

Masonry, stucco, weathered wood, and bare substrates often take more paint than smooth, previously painted siding. Some interior-style data sheets still list 350–400 sq ft/gal; some exterior products list 250–300 sq ft/gal at a thicker film. Use the data sheet for the coating and the surface you have. This tool does not add a separate waste factor for spray loss, because we do not have a sourced standard rate for that. If you have measured soffits, trim, or a wing wall, fold that area into the rectangle or run the calculator a second time for those surfaces.

Sources and notes

  • Default 250 sq ft per US gallon: low end of “250–300 sq. ft. per gallon” on the Sherwin-Williams Duration Exterior Acrylic Flat product data sheet (at 5.3–6.4 mils wet). That is a thicker recommended film than the 4 mils wet often listed with 350–400 sq ft/gal interior paints.
  • The general 350–400 sq ft/gal planning range on the Sherwin-Williams paint calculator FAQ is still useful when your exterior product lists that rate; enter it in the coverage field.
  • This page is not a brand’s official exterior calculator.

Disclaimer: These tools give planning estimates only. Coverage, sheet sizes, batt dimensions, bag yields, and R-values vary by product, surface, installation, and climate. Always check the label or data sheet for the product you buy, and follow the adopted local building code and a qualified professional for any code-regulated, fire-rated, moisture, or structural work. Interior Reference is not a contractor, retailer, or building-code authority, and it does not replace manufacturer instructions or a licensed designer.