Planning Tools for Paint, Wallboard, and Insulation
A small set of finishing and thermal-envelope tools — paint quantity, drywall and plasterboard counts, insulation quantity, and R-value charts — with the formulas and published sources written on each page.
Reference tools
Use these pages to estimate paint for a room or an exterior wall, count US drywall or UK plasterboard sheets, plan batt or blown-in insulation, and look up published coverage and R-value figures. Each calculator states its formula and the source behind any default rate. This homepage is a hub for those tools — it is not a generic “paint calculator” landing page.
How the estimates are calculated
For a rectangular room, wall area is 2 × (length + width) × height. Ceiling or attic-floor area is length × width. Paint quantity is (paintable area × coats) ÷ coverage. Drywall or plasterboard count is net area × (1 + waste fraction) ÷ sheet area, rounded up. Blown-in bag counts use (area ÷ 1,000) × bags per 1,000 sq ft from a published chart or from the figure you enter off the bag.
Example: a 12 ft × 10 ft room with 8 ft ceilings has 2 × (12 + 10) × 8 = 352 sq ft of wall. At two coats and 350 sq ft per gallon, that is 704 ÷ 350 = 2.01 US gallons before any openings are subtracted. The same arithmetic is shown, with sources, on the dedicated tool pages.
Sources for default figures
Defaults on this site are taken from published manufacturer or government figures and are always editable:
- Interior paint coverage default of 350 sq ft per US gallon: the low end of the 350–400 sq ft range on the Sherwin-Williams paint calculator FAQ and on product data sheets such as SuperPaint Interior Latex.
- US drywall sheet sizes: USG Sheetrock Brand product data (4 ft wide panels; common lengths 8–14 or 8–16 ft depending on the panel; 1/4, 3/8, 1/2, and 5/8 in thicknesses).
- UK plasterboard sizes: British Gypsum Gyproc WallBoard data (for example 1200 × 2400 mm).
- Recommended insulation levels and existing-insulation multipliers: ENERGY STAR recommended home insulation R-values and the ENERGY STAR DIY inspection table.
Disclaimer: These tools give planning estimates only. Coverage, sheet sizes, batt dimensions, bag yields, and R-values vary by product, surface, installation, and climate. Always check the label or data sheet for the product you buy, and follow the adopted local building code and a qualified professional for any code-regulated, fire-rated, moisture, or structural work. Interior Reference is not a contractor, retailer, or building-code authority, and it does not replace manufacturer instructions or a licensed designer.